This happens event for +1G (which is smaller than the previously-existing partition) - indeed, it even happens if I try to create a partition of size +3M, which is what the default successfully does! ( +2M, however, succeeds)ĮDIT: prompted by comment, I tried creating a new (3rd) partition without first deleting the existing partition - this, likewise, defaulted to 3MiB size, and did not allow the ~900Mb size that I would have expected (3.1G - (256M + 1.9G) ~= 900M). If I quit fdisk, and retry, trying to explicitly set a larger size (such as +2G) for the "Last sector" value, I get Value out of range. Note that, following the defaults, the newly-created partition is only 3 MiB, which is smaller than the 1.9G previous partition. Last sector, +/-sectors or +/-size (2048-8191, default 8191):Ĭreated a new partition 2 of type 'Linux' and of size 3 MiB. P primary (1 primary, 0 extended, 3 free)Į extended (container for logical partitions)įirst sector (2048-6488063, default 2048): I/O size (minimum/optimal): 512 bytes / 512 bytesĭevice Boot Start End Sectors Size Id Type Sector size (logical/physical): 512 bytes / 512 bytes Referring back to this guide, here is what I did: $ sudo fdisk /dev/sdaĬhanges will remain in memory only, until you decide to write them.īe careful before using the write command.ĭisk /dev/sda: 3.1 GiB, 3321888768 bytes, 6488064 sectors I think that this is because I also need to extend the partitions on the disk. Mac raspberry pi emulator install#However, the actual available disk space remains the same - that is, df still reports the same %ge of disk usage, and I still get "out of space" errors when trying to install software. However, once I started installing software, I swiftly ran out of space.īy using qemu-img resize (as prompted by here and here), I am able to resize the image such that sudo fdisk -l's output changes from reporting, say, Disk /dev/sda: 2.1 GiB to Disk /dev/sda: 3.1 GiB. The Image boots perfectly well, and I can interact with it either via the popped-up terminal or by ssh-ing to the hosted device. Mac raspberry pi emulator mac#I followed this guide to emulate a Raspbian image on my Mac - the only change I made was to use a Buster Lite image.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |